Call: (931) 389-6444
Plastic and Aluminum Moldings for the air plane industryMoldings for the RV IndustryModlings for the Boat Industry Moldings for the automobile industry
Yachts, private aircraft, recreation vehicle drapery hardware and automotive small plastic parts

A100 Aluminum Vertical Mount Drapery Track

Aluminum hand-drawn track with vertical flange is normally affixed directly to wall using standard fasteners. This track can also be recessed, depending on application.

Extruded 6063-T5 aluminum track is etched, anodized, and siliconized. Clear satin finish is rust proof and chip proof.  Track comes in 16 ft standard lengths, but can be cut to length for an additional charge.

Track should be mounted to wood using standard fasteners, or to plaster using #6, #8, or #10 screws, positioned 4" apart. Installation should allow 1/4" clearance between track end and end wall. Install carriers, gliders, or sew-on tabs at 3" on center. Draperies should be attached starting at the center, removing or adding carriers as needed at the notches on either end of the track. Complete installation using M-114 or M-115 end stops.

Channel Height: 0.195”

Channel Width: 0.245”

Total Height: 0.655"

Total Width" 0.325”